Cruise Control Trainer

Cruise Control Trainer

Variable load control
OEM components

SPECIFICATION:-  
The cruise control takes its speed signal from a rotating driveshaft, speedometer cable, wheel speed sensor from the engine’s RPM, or from internal speed pulses produced electronically by the vehicle.
The vehicle will maintain the desired speed by pulling the throttle cable with a solenoid, a vacuum driven servomechanism, or by using the electronic systems built into the vehicle (fully electronic) if it uses a ‘drive-by-wire’ system.
External Power Supply: AC 220V 10% 50Hz
Operating Voltage: 12V DC
On/off button
Set/accel peddle
Resume button
Brake peddle
Clutch peddle